Raritan PX3TS, User Manual, Page: 525 / 842

Chapter 8: Using the Command Line Interface
501
3. The config:# prompt appears, indicating that you have entered
configuration mode.
4. Now you can type any configuration command and press Enter to
change the settings.
Important: To apply new configuration settings, you must issue the
"apply" command before closing the terminal emulation program.
Closing the program does not save any configuration changes. See
Quitting Configuration Mode (on page 501).
Quitting Configuration Mode
Both of "apply" and "cancel" commands let you quit the configuration
mode. The difference is that "apply" saves all changes you made in the
configuration mode while "cancel" aborts all changes.
To quit the configuration mode, use either command:
config:# apply
-- OR --
config:# cancel
The # or > prompt appears after pressing Enter, indicating that you have
entered the administrator or user mode. See
Different CLI Modes and
Prompts (on page 465).
PX3TS Control and Configuration
To configure the PX3TS device or network settings through the CLI, it is
highly recommended to log in as the administrator so that you have full
permissions.
To configure any settings, enter the configuration mode. Configuration
commands are case sensitive so ensure you capitalize them correctly.
Controlling the Transfer Switch
A transfer switch command begins with ts. You can use these commands
to control the power transfer behavior or manage power transfer
settings.