Raritan PX3-3000 series, User Manual

Page: 726 / 875

Appendix E: Resetting to Factory Defaults
702

PX3 models:

PX3-iX7 models:
Note: HyperTerminal is available on Windows operating systems prior to
Windows Vista. For Windows Vista or later versions, you may use PuTTY,
which is a free program you can download from the Internet. See
PuTTY's documentation for details on configuration.
Using the CLI Command
The Command Line Interface (CLI) provides a reset command for
restoring the PX3 to factory defaults. For information on CLI, see
Using
the Command Line Interface
(on page 444).
To reset to factory defaults after logging in to the CLI:
1. Connect to the PX3 device. See
Logging in to CLI
(on page 445) or
Connecting the PX3 to a Computer
(on page 32).
2. Launch a terminal emulation program such as HyperTerminal,
Kermit, or PuTTY, and open a window on the PX3. For information on
the serial port configuration, see Step 2 of
Initial Network
Configuration via CLI (on page 812).
3. Log in to the CLI by typing the user name "admin" and its password.
4. After the # system prompt appears, type either of the following
commands and press Enter.
# reset factorydefaults
-- OR --
# reset factorydefaults /y
5. If you entered the command without "
/y
" in Step 4, a message
appears prompting you to confirm the operation. Type y to confirm
the reset.