Raritan PX3-3000 series, User Manual, Page: 468 / 875

444
This section explains how to use the command line interface (CLI) to
administer a PX3 device.
CLI commands are case sensitive.
In This Chapter
About the Interface.................................................................................. 444
Logging in to CLI...................................................................................... 445
The ? Command for Showing Available Commands............................... 448
Querying Available Parameters for a Command.................................... 449
Showing Information ............................................................................... 450
Clearing Information ............................................................................... 482
Configuring the PX3 Device and Network ............................................... 483
Load Shedding Configuration Commands .............................................. 618
Power Control Operations....................................................................... 620
Actuator Control Operations ................................................................... 623
Unblocking a User ................................................................................... 625
Resetting the PX3 .................................................................................... 625
Network Troubleshooting ....................................................................... 627
Retrieving Previous Commands.............................................................. 630
Automatically Completing a Command .................................................. 630
Logging out of CLI ................................................................................... 631
About the Interface
The PX3 provides a command line interface that enables data center
administrators to perform some basic management tasks.
Using this interface, you can do the following:

Reset the PX3 device

Display the PX3 and network information, such as the device name,
firmware version, IP address, and so on

Configure the PX3 and network settings

Troubleshoot network problems
You can access the interface over a local connection using a terminal
emulation program such as HyperTerminal, or via a Telnet or SSH client
such as PuTTY.
Note: Telnet access is disabled by default because it communicates
openly and is thus insecure. To enable Telnet, see
Changing Telnet
Settings
(on page 281).
Chapter 8 Using the Command Line Interface