Raritan PX3-1000 series, User Manual

Page: 177 / 744

Chapter 6: Using the Web Interface
155
State Description
fault The iX7
™
controller cannot receive power from its
inlet because of a power failure on the inlet or a
broken 12V power supply. Instead it receives power
from another iX7
™
PDU. See
Power-Sharing
Restrictions and Connection (for iX7
™
Only) (on
page 47).
After entering the fault state, this sensor is listed in
the Alerted Sensors section of the Dashboard. See
Dashboard (on page 135).
unavailable The communication with the 12V power supply
sensor is lost.
Alternatives for checking the 12V power supply status:

Dot-matrix LCD panel. See
PDU
(on page 99).

CLI command:
show pdu details
. See Using the Command Line
Interface
(on page 365).
Inlet
You can view all inlet information, configure inlet-related settings, or
reset the inlet active energy on the Inlet page. To open this page, click
'Inlet' in the
Menu (on page 132).
Inlet thresholds, when enabled, help you identify whether the inlet enters
the warning or critical level. In addition, you can have the PX3
automatically generate alert notifications for any warning or critical
status. See
Event Rules and Actions
(on page 272).
Note: If your PX3 is a multi-inlet model, see Configuring a Multi-Inlet
Model
(on page 157).
Generic inlet information shown:

Inlet power overview, which is the same as Dashboard - Inlet I1 (on
page 137).

A list of inlet sensors with more details. Number of available inlet
sensors depends on the model.

Sensors show both readings and states.

Sensors in warning or critical states are highlighted in yellow or
red.
See
Yellow- or Red-Highlighted Sensors
(on page 180).