Raritan PX2-1000 SERIES, User Manual

Page: 41 / 648

Chapter 3: Installation and Configuration
22
Note: To use the Edimax EW-7722UnD or Raritan USB WIFI wireless
LAN adapter to connect to an
802.11n
wireless network, the handshake
timeout setting must be changed to 500 or greater, or the wireless
connection will fail.
Supported Wireless LAN Configuration
If wireless networking is preferred, ensure that the wireless LAN
configuration of your PX matches the access point. The following is the
wireless LAN configuration that the PX supports.
 Network type: 802.11 A/B/G/N
 Protocol: WPA2 (RSN)
 Key management: WPA-PSK, or WPA-EAP with PEAP and
MSCHAPv2 authentication
 Encryption: CCMP (AES)
Important: Supported 802.11 network protocols vary according to the
wireless LAN adapter being used with the PX. See
USB Wireless LAN
Adapters (on page 21).
Initial Network Configuration via CLI
After the PX is connected to your network, you must provide it with an IP
address and some additional networking information.
This section describes the initial network configuration via a serial
RS-232 or USB connection. To configure the network settings using the
web interface, see
Modifying the Network Configuration
(on page
112).
To configure the PX device:
1. On the computer connected to the PX, open a communications
program such as HyperTerminal or PuTTY.
2. Select the appropriate COM port, and set the following port settings:
 Bits per second = 115200 (115.2Kbps)
 Data bits = 8
 Stop bits = 1
 Parity = None
 Flow control = None