Raritan PX2-1000 SERIES, User Manual, Page: 342 / 648

323
This SNMP section helps you set up the PX for use with an SNMP
manager. The PX can be configured to send traps or informs to an
SNMP manager, as well as receive GET and SET commands in order to
retrieve status and configure some basic settings.
In This Chapter
Enabling SNMP .....................................................................................323
Configuring Users for Encrypted SNMP v3 ...........................................324
Configuring SNMP Notifications ............................................................325
SNMP Gets and Sets ............................................................................330
Enabling SNMP
By default, SNMP v1/v2c is enabled on the PX so the PX can
communicate with an SNMP manager. If you have disabled the SNMP, it
must be enabled to communicate with an SNMP manager.
Note that read-only access is enabled and the community string is public.
To enable SNMP:
1. Choose Device Settings > Network Services > SNMP. The SNMP
Settings dialog appears.
Chapter 7 Using SNMP