Raritan PMC-1000, User Manual, Page: 212 / 621

Chapter 3: Using the Web Interface
200
Enabling Service Advertising
The BCM2 advertises all enabled services that are reachable using the IP
network. This feature uses DNS-SD (Domain Name System-Service
Discovery) and MDNS (Multicast DNS). The advertised services are
discovered by clients that have implemented DNS-SD and MDNS.
The advertised services include the following:
• HTTP
•
HTTPS
•
Telnet
•
SSH
•
Modbus
• json-rpc
• SNMP
By default, this feature is enabled.
Enabling this feature also enables Link-Local Multicast Name Resolution
(LLMNR) and/or MDNS, which are required for resolving APIPA host
names. See APIPA and Link-Local Addressing.
The service advertisement feature supports both IPv4 and IPv6 protocols.
If you have set a preferred host name for IPv4 and/or IPv6, that host
name can be used as the zero configuration .local host name, that is,
<preferred_host_name>.local, where <preferred_host_name> is the
preferred host name you have specified for BCM2. The IPv4 host name is
the first priority. If an IPv4 host name is not available, then use the IPv6
host name.
Note: For information on configuring IPv4 and/or IPv6 network settings,
see
Wired Network Settings
(on page 170).
To enable or disable service advertising:
1. Choose Device Settings > Network Services > Service Advertising.
2. To enable the service advertising, select either or both checkboxes.

To advertise via MDNS, select the Multicast DNS checkbox.

To advertise via LLMNR, select the Link-Local Multicast Name
Resolution checkbox.
3. Click Save.