Raritan PMC-1000, User Manual

Page: 163 / 621

Chapter 3: Using the Web Interface
151
SHX Request Maximum Cooling
The BCM2 allows you to remotely activate the Schroff SHX 30's
maximum cooling feature. Both LHX 20 and LHX 40 do not support
remote activation of maximum cooling.
The Request Maximum Cooling feature is available only after the BCM2
detects SHX 30. For additional information on the SHX 30 maximum
cooling feature, see the SHX 30 documentation.
To perform maximum cooling:
•
Go to the SHX page, and click Request Maximum Cooling.
Then the SHX 30 enters into emergency cooling mode and runs at its
maximum cooling level of 100% in order to cool the device.
When maximum cooling is requested for an SHX 30, the message
"Maximum cooling requested" is displayed.
To stop maximum cooling:
•
Click Cancel Maximum Cooling.
Power CIM
After connecting and detecting a Raritan power CIM, the BCM2 shows
'Power CIM' in place of 'Feature Port' in the menu. See Dominion KX II /
III Configuration or Dominion KSX II, SX or SX II Configuration.
Open the Power CIM page by clicking it in the Menu. This page shows the
CIM's status, including:
•
Number of the FEATURE port where this CIM is connected
•
Its device type
• Its connection status
For the functionality of this icon on the top-right corner, see Feature
Port (on page 134).