Chapter 2: DX2 Series
13
See
Configuring DX2-CC2's Normal State
(on page 15).
Connecting Detectors/Switches to DX2-CC2
DX2-CC2 comprises two parts: sensor box and terminal module. The
terminal module is detachable so it is convenient to connect/disconnect
discrete detectors/switches.
To make connections when the terminal module is attached:
1.
Strip the insulation around 12 mm from the end of each wire of
discrete detectors/switches.
2.
Fully insert each wire of both detectors/switches into each
termination point.
Plug both wires of a detector/switch into the two termination
points to the left.
Plug both wires of the other detector/switch into the two
termination points to the right.
