8
CAUTION
• If the Reset Pushbutton does not reset the inverter, turn the ON/OFF switch off, then on again.
• If turning the ON/OFF Switch off, then on again does not reset the inverter, DO NOT ATTEMPT TO OPEN THE
INVERTER. Opening the inverter for any reason will void the warranty. The unit must be returned to manufacturer
for testing and repair by professional factory technicians.
INSTALLATION
Your inverter will provide you with continuous electrical power when powered by a reliable 12 volt DC source, such
as a vehicle battery or a multiple battery configuration. This manual does not describe all of the possible
configurations.
Operating Environment
For best operating results, your inverter should be placed on a flat surface, such as the ground, car floor or seat,
or other solid surface to help diffuse the heat that is generated. Position the inverter as close to the DC power
source as possible.
The inverter should only be operated in locations that meet the following criteria:
DRY – Do not allow water and/or other liquids to come into contact with the inverter.
COOL – Ambient air temperature should be between 30°F (–1°C) non-condensing and 105°F (40°C). Do not place
the inverter on or near a heating vent or any piece of equipment that is generating heat above room temperature.
Keep the inverter out of direct sunlight.
VENTILATED – Allow at least three inches of clearance from other objects to ensure free air circulation around the
inverter. Never place items on or over the inverter during operation.
SAFE – Do not locate inverters in an area, room or compartment where explosives or flammable fumes might be
present, such as engine rooms, engine compartments, and boats or small, unvented battery compartments.
Marine Applications
In all marine applications, DO NOT install the inverter below or near the waterline, and keep the inverter away from
moisture and water.
Use ONLY non-corrosive marine fasteners and fittings for installation. Only connect the inverter’s DC input to
existing wiring (that has been approved for marine use) at the appropriate gauge, cable and length. The cable, fuse
holder and fuse (not supplied) can be purchased at an electrical supply company. Call the manufacturer for
additional installation information.
Connecting to a Power Source Using the DC Accessory Outlet Plug
The DC Accessory Outlet Plug is suitable for operating the inverter at power outputs up to 100 watts. The tip of
the plug is positive (+) and the side contact is negative (–).
Connect the inverter to the power source by inserting the DC Accessory Outlet Plug firmly into the accessory outlet
of a vehicle or other DC power source.
Once properly connected to a 12 volt DC power source, the green Power LED will light, indicating the inverter is
functioning properly. If the red Fault LED lights, a fault condition exists. Refer to the “Troubleshooting” section of
this Instruction Manual.
CAUTION
• Connect directly to power source using the included Battery Clips when operating above 100 watts.
• Do not use with positive ground electrical systems.
• Reverse polarity connection will result in a blown fuse and may cause permanent damage to the inverter.
Permanent Installation (Cables and Fuse Not Supplied)
Note: Most vehicle accessory outlet circuits have fuses rated at 15 to 20 amps or greater. To operate at full wattage,
either use the supplied battery clips or directly wire to the power source with wire and fuse (NOT SUPPLIED).
Connecting to a Power Source Using the Supplied Battery Clips
Use the provided Battery Clips (with cables) to connect the Power Inverter directly to the 12 volt power source as
follows:
1. Check to make sure the inverter’s Power Switch has been turned off (no LEDs are lit) and that no flammable
fumes are present in the installation area.
2. Connect the red cable to the red post marked (+) on the back of the inverter . Connect the red battery clip to the
