REV JUNE 2020
Rapid Spray Marshal Pro Operators Handbook
11
•
= Reel powered correctly, on standby, ready to operate
•
= Reel has not been paired to a remote
•
= Reel is in pairing mode
•
= Supply voltage to reel is too low
•
= Reel is rewinding at the fast setting
•
= Reel is rewinding at the slow speed
Your Buddy Smart Reel
®
is equipped with a display to indicate its current status. During
operation of your reel you may observe the following messages on the display.
0
nP
PA
LL
FA
SL
Slow flash
Very fast flash
Fast flash
Very fast flash
Fast flash
Unit in
pairing mode
Fast rewind
button pressed
Slow rewind
button pressed
Battery low and fast
rewind pressed
Battery low and slow
rewind pressed
PAIRING MYPACE REMOTE TO BUDDY SMART REEL®
The MyPace handheld remote should be delivered already paired to the Buddy
Hose Reel. If
several reels have been purchased and it is not clear as to which remote is
paired to which reel or if the remote has been replaced, the remote can be re-paired to the
reel at any time.
How to pair the MyPace remote
1.
Stand within reach of the Buddy Reel switch panel.
2.
Ensure the reel is powered and switched on.
3.
Remove the batteries from the remote.
4.
Press both buttons on the remote and insert the batteries while holding the buttons.
5.
Green lights will flash slowly on the remote and the display on the switch panel on the
reel will slowly flash
PA
.
6.
Within 10 seconds, press the manual rewind button on the reel switch panel.
7.
Successful pairing will be acknowledged by the display on switch panel flashing PA
fast for a few seconds then return to a steady
0
. (The green light on the remote may
continue to flash slowly for a few seconds then stop).
8.
After the green light on the remote stops flashing, press either button to confirm that
the reel is responding.
READING LED LIGHTS & SWITCH PANEL CODES
