Operating Instructions RS cure
│
D cure
│
P cure
│
SHERAprint cure
│
3Decure
19
│
27
Rapid Shape GmbH
│
DOCR000251
For the curing of residual material, the complete
disposable reservoir (D10+ capsule) can be placed in
the exposure chamber.
6.4
Select Operating Mode & Start
To start the curing process, you can choose from the following three
operating modes:
—
Operating mode
‚
Jobs
’
→
Chapter 6.4.1
—
Operating mode
‚M
aterial
’
→
Chapter 6.4.2
—
Operating mode
‚
Custom
’
→
Chapter 6.4.3
6.4.1
Operating Mode
‚Job
s
’
In the
‚Jobs’
operating mode, the curing process is performed based
on the print job submitted. To start the process, please proceed as
follows:
1.
Prerequisites: There is a connection between the post curing unit
and the 3D printer.
→
Chapter 4.3.3
The exposure chamber is properly loaded.
→
Chapter 6.3
2.
Go to Home screen.
3.
Select the
‚Jobs’
tab.
4.
Select the respective print job.
5.
Press the
‚Start’
button. The curing process starts, the current
progress is shown on the display.
Figure 3: Home screen, job selection
The exposure parameters (e.g. the exposure time,
vacuum/protective gas) are selected based on the print
job.
For safety reasons, the machine should not be opened
during the curing process. If it is still opened, the
program aborts immediately.
