Operating Instructions D50+ | P50+ | SHERAprint 50
81
│
96
Rapid Shape GmbH
│
DOCR000438
10.1.8
Checking the Separation Unit
CAUTION!
Risk of injury due to sharp objects!
The knife on the separation unit has a sharp edge that
can cause slight hand injuries through direct contact.
–
The edge should never be touched directly.
Only hold the knife by the knurled nuts and with
the blade away from your body.
NOTE!
Wearing protective gloves protects the skin from contact
with skin damaging materials. During work steps in
which you work with printing materials or cleaning
agents, we always recommend wearing protective
gloves.
The knife of the separation unit needs to be visually inspected regularly
for signs of wear.
Required Accessories
Safety gloves, isopropanol, paper towels, brush/small brush
Execution
For checking the knife visually, please proceed as follows:
1.
Wear protective gloves on your hands.
2.
Spread out several paper towels on the work surface.
3.
Remove the knife and clean it.
→
Chapter 10.1.3
4.
Afterwards check the blade of the knife for damage,
deformations, deposits, and other abnormalities. A knife with
signs of wear needs to be replaced.
→
Chapter 10.1.13
5.
If there are no abnormalities, place the knife back into the
holder on the machine and press it down until it is fully
engaged.
Take note of the side markings (left/right) on the knife
carrier plate while doing so.
6.
Insert the knife protection device back into the machine and
push it back as far as it will go to close the knife protection
device.
7.
Take the collection basket and place it in the mounting.
8.
Close the upper hood.
