SAB-Q2 Quick Start
January 12, 2011
SAB-Q2 Quick Start
This document aims to provide a systematic setup procedure to enable you to setup and use your SAB-Q2
as easily as possible. This guide will concentrate on connections and basic setup. More information is
available for advanced setup, refer to the SAB-Q2 manual. If you do not have a SAB-Q2 manual, call
Rapid Controls or visit the Rapid Controls website, www.rapidcontrols.com.
Figure 1: SAB-Q2 Connector and Jumper Placement
1. Power Connection (Connector J4)
Power input to J4 provides power to the board and the sensors. Refer to the sensor requirements before
choosing a power source for the SAB-Q2. The following pins must be connected:
Pin 1 is connected to 24VDC or +15VDC depending on the requirements of the sensor.
Pin 2 is connected to ground.
Pin 3 is connected to –15VDC if required by the sensor. Otherwise, no connection is made.
Rapid Controls Inc.
Box 8390
Rapid City, SD
57709
Phone: 605-348-7688
Fax: 605-341-5496
http://www.rapidcontrols.com/
email: [email protected]
