61
5.
Tug on the two cables to check if there is slack and that they are not being
squeezed/impinged by the hinge. If there is not any slack on the cables, remove the
hinge and then repeat the steps above.
12-Pin Daughter Board Cable
When routing the 12-pin daughter board cable, follow the instructions below:
•
Route the (A) hinge board cable (labeled “CoveR”) through the opening at the top of
the machine’s middle column.
A
Summary of Contents for FREDDA 1.0
Page 1: ...AI Rapid Cold Brew Maker Service Guide...
Page 2: ......