52
4.
Unthread the 6-pin stirrer motor cable from the slit in the top cover to remove it.
To install the 6-pin stirrer motor cable, reverse the steps above. Ensure you also follow
the cable routing instructions in “Stirrer Motor and Button Board Cable” on page 59.
Replacing the 12-Pin Button Board Cable
1.
Remove the hinge. See “Removing the Hinge” on page 50 for instructions.
2.
Follow steps 1 - 3 in the Stirrer Motor section to open the operation panel. See
“Replacing the Stirrer Motor” on page 42 for instructions.
3.
Disconnect the 12-pin button board cable from the button board.
√
√
NOTE:
The cable connector features a latch that requires the user to pinch in
order to disconnect it from the button board.
Summary of Contents for FREDDA 1.0
Page 1: ...AI Rapid Cold Brew Maker Service Guide...
Page 2: ......