59
Cable Routing
Stirrer Motor and Button Board Cable
When routing the stirrer motor and button board cable, follow the instructions below:
1.
Thread the two cables through the slit at the rear of the top cover.
2.
Route the two cables squarely in the center of the U-shaped cut-out/gap at the rear
of the top cover.
!
CAUTION:
The cables MUST be tightly routed in the center of the cut-out/gap,
if not they will be damaged by the hinge.
Summary of Contents for FREDDA 1.0
Page 1: ...AI Rapid Cold Brew Maker Service Guide...
Page 2: ......
