Ransburg 75785, Service Manual, Page: 27 / 78

AH-94-04.7
REA-90 and 90L Spray Applicators - Installation
2 2 2 2 2 2 2 2 2 2
FLUID HOSE FITTING FLUID HOSE FITTING
FLUID HOSE FITTING FLUID HOSE FITTING
FLUID HOSE FITTING
INST INST INST INST INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
(Refer to Figure 4) (Refer to Figure 4) (Refer to Figure 4) (Refer to Figure 4) (Refer to Figure 4)
ITW Ransburg supplies a standard 36-foot hose.
Optional hose lengths of 50, 75, 100, and 150 feet
are available. To meet various length requirements,
the hose fitting on one end has not been attached.
Determine the hose length that is needed and cut
the hose off squarely. Attach the other fitting as
follows.
1. Lightly lubricate all threaded areas with
dielectric grease or petroleum jelly.
2. Screw the ferrule counter-clockwise onto hose
until it bottoms. Then screw clockwise
approximately 1/8-inch.
3. Install the nut over the union stem, lubricate the
stem, and start the stem into the hose, using care
not to catch the hose lining with the stem tip.
4. Using a 3/16-inch Allen wrench, screw the
union stem into the hose until it bottoms against the
ferrule.
5. Connect one end of the hose to the fluid fitting
at the bottom of the applicator handle and the other
end to the appropriate fluid source.
Figure 4: Fluid Hose Assembly Figure 4: Fluid Hose Assembly
Figure 4: Fluid Hose Assembly Figure 4: Fluid Hose Assembly Figure 4: Fluid Hose Assembly
AIR HOSE FITTING AIR HOSE FITTING AIR HOSE FITTING AIR HOSE FITTING AIR HOSE FITTING
INST INST
INST INST INSTALLA
ALLA
ALLA ALLA ALLATION
TION
TION TION TION
(Refer to Figure 4) (Refer to Figure 4)
(Refer to Figure 4) (Refer to Figure 4) (Refer to Figure 4)
ITW Ransburg supplies a standard 36-foot hose.
Optional hose lengths of 50, 75, 100, and 150 feet
are available. To meet various length requirements,
the hose fitting on one end has not been attached.
Determine the hose length that is needed and cut
the hose off squarely. Attach the other fitting using
the same procedure used for the fluid hose fitting
installation.
P P
P P
PAINT AINT
AINT AINT
AINT PREP PREP
PREP PREP
PREPARA ARA
ARA ARA
ARATION TION
TION TION
TION
A proper paint mixture is essential to electrostatic
operation. Paint test equipment may be obtained
through your ITW Ransburg representative.
Reference Technical Manual "Paint Related
Information for REA, Vector, REM, and M90
Applicators" for paint formulation information. For
further paint formulation and testing procedures,
consult your ITW Ransburg representative and/or
your paint supplier.
>
The union stem will not seat if the
hose is bottomed against the ferrule.
N O T E N O T E
N O T E N O T E
N O T E