09/11/2018
RANS S-21 OUTBOUND
TEXT MANUAL
106
16.
Route the cable through the cable housing swivel stop and through the wire
swivel stop in the control arm of the park brake valve. Be sure to install the
short length of blue fuel line to act as an up stop.
17.
Adjust the control arm and cable to allow full open valve with the control
knob pushed in and closed with knob pulled out. Slide a short piece of fuel
line onto the wire between swivel stops to limit travel. Refer to
RIGGING
for
more details.
18.
Adjust the cable friction using the screw in the friction block as desired.
19.
Loctite the screw in the wire swivel stop. Safety wire the cable housing to
the Swivel Stop.
SLIDING SEAT ASSEMBLY
FUSELAGE PREPARATION
(BEFORE SKINNING AND PAINTING OF FUSELAGE)
1.
Use a 16" x1/4" diameter steel or brass rod. Clamp the rod and seat rails in the
location per
FIGURE 09D-01
. Cleco as you drill.
2.
Drill the #11 holes to 1/4". Install Rivet Nuts. If you do not have a Rivet-Nut puller,
refer to
FIGURE 09D-02
for the procedure to install them.
3.
Fabricate Seat Stop Tubes from raw stock. Using loc-tite, bolt Stop Tubes and
Sliding Seat Position Rail to installed rivet nuts.
SEAT ASSEMBLY - (FINISHING KIT)
1.
Trim lower end of Seat Back Frames per
FIGURE 09D-04
. Doublers have been
installed in the Seat Back Frame prior to the lumbar bend. Drill them out to #11
using the frame holes as a guide. Countersink the outboard seat side plates of
each seat assembly for the flush head bolts. Bolt the Seat Plates to each leg of
the Seat Back with countersunk plates on the outside of the Seat Frame. Refer
to
FIGURE 09D-04
for orientation. Leaving the nuts slightly loose at this time will
aid in installing the Seat Bottom Frame.
2.
Modify Seat Bottom Frame per
FIGURE 09D-05
.
HINT
: Pull an aluminum tube or straight edge along the bottom to mark a
centerline on each tube.
3.
The Slider Block will rivet to the Seat Bottom Frame after the Bottom Cushion is
installed.
4.
Modify 8 Multi-Hole Tangs per
FIGURE 09D-08
. Rivet Multi-Hole Tangs to
inside and outside of each Seat Bottom Frame.
