Rans COYOTE II S-6ES, Technical Manual

Page: 193 / 341

020220wg msw 09/01/05
022F-1
WING TIP INSTALLATION
The Wing should be covered with Aileron attached to properly install the Wing Tip.
1.
Trim the Thermo-formed wing tips to just before the material base radius.
2.
Place 2” masking tape inboard of the #40 mounting holes in the Upper & Lower Tip Skins. Mark a line
inboard on the tape, aligned with each hole. Measure inboard from the center of each hole 1 1/2” and
place an intersecting mark. This will allow locating the mounting holes after the Wing Tip is in place.
3.
Slide the Wing Tip onto the outboard end of the wing. The Wing Tip should extend 1/2” past the
mounting holes in the Upper & Lower Tip Skins.
HINT: Measure 1” from the lines marked on the tape.
Be sure the top of the Wing Tip is straight with the top of the Wing. Use tape to hold the tip in place.
4.
Locate all #40 mounting holes under the tip. Drill and Cleco the tip to the wing.
5.
Trim the aft end of the Wing Tip to clear the Aileron by about 3/16”.
6.
Slide the small metal rib inside the aft end of the Wing Tip and clamp in place.Trim the rib flanges as
needed to allow a flush fit. Mark three (3) holes, top and bottom, on the Wing Tip approximately
centered on the rib flange. Drill #30 and rivet.
7.
Remove the tip, final trim, prep and paint for final installation.