RML-600XL ATV / Motorcycle Lift
14
P/N 5900381 — Rev. D — June 2019
The following procedure describes installing both the Platform Extension and the Side Extensions.
BendPak Ranger recommends a minimum of two people to install the Platform Extension, Side
Extensions, and the Ramps.
Use the drawing on the previous page in conjunction with the following procedure.
To install the Platform Extension and Side Extensions
:
1.
Locate the Platform Extension, two Side Extensions, two Connecting Rods, four Lock Bolts, four
Cotter Pins, two Eyelet Bolts, the Main Ramp, and two Side Extension Ramps.
2.
Put the Main Ramp into position, on the Ramp End of the Main Platform.
The hooks on all of the Ramps go into corresponding holes on their Platform.
3.
Slide the Platform Extension over the Main Platform, on the Clamp end of the Main Platform.
The Platform Extension has holes for the Clamp just as the Main Platform does.
4.
Slide the two Connecting Rods into place, through the Main Platform on each end.
The ends of the Connecting Rods are going to stick out through the Main Platform until you put
the Side Extensions into place.
5.
Put one of the Side Extensions into place by sliding it over the Connecting Rods.
Only one end of each Side Extension has an Eyelet Bolt Hole in it; put that end at the Clamp End
of the Lift.
6.
Put the second Side Extension into place the same way as you did the first one.
7.
Put a Lock Bolt and Cotter Pin into place on all four exposed ends of the Connecting Rods.
8.
Put the Extension Ramps into place on the Ramp End of each Side Extension.
9.
Put the two Eyelet Bolts into place.
