Ranger GoCar RCD-1500, Setup And Operation Manual

Page: 10 / 16

GoCart™ Rolling Car Dollies
10
P/N 5900207 — Rev. B — September 2021
• Annually : Replace the Hydraulic Oil in the reservoir.
o
Oil change procedure:

Check the Oil, place the Dolly on level ground and expand the Rollers apart.

Remove the Oil Filler Plug. The plug is on the far side of the cylinder. See figure
below. The Oil level should be filled to the bottom of the Filler Plug Hole.

Add approved Anti-Wear Hydraulic Jack Oil as required, and secure the Oil Filler
Plug.
⚠
WARNING Use Anti-Wear Hydraulic Jack Oil only. The use of Alcohol, Hydraulic Brake Fluid,
Detergent Motor Oil, or Transmission Fluid could damage the internal Seals and
result in Positioning Jack failure.

Perform the bleeding procedure below.
o
Bleeding procedure:

Open the Release Valve by turning it counterclockwise. Do
not
turn the Release
Valve counterclockwise more than two full turns. Hydraulic Fluid will leak from the
Positioning Jack.

Pull the Rollers apart to the fully open position.

Carefully remove the Foot Pedal Stow Hook (the Pedal is Spring-loaded) and pump
the Foot Pedal at least five full strokes.

Close the Release Valve.

The Positioning Jack is ready to use.
If you continue to have problems with your equipment, take the equipment out of service, then contact
your dealer, visit bendpak.com/support , email support@bendpak.com , or call (800) 253-
2363 , extension 196.