DST30P Wheel Balancer
38
P/N 5900163 — Rev. C1 — March 2020
Switching Inches and Millimeters for Diameter
When you are entering measurements for a Wheel, you can have the values for Wheel Diameter display
in either Inches or Millimeters. The default is Inches.
To switch from Inches and Millimeters for Wheel Width measurements
:
1.
Turn the Balancer Off and then back On again using the On/Off Switch.
This sets the Wheel Diameter display setting back to the default, Inches.
2.
Specify a Distance value and then a Width value.
3.
Press the
+
or
–
button under
Diameter
.
-d-
appears on the Inner Window and a value appears in the Outer Window.
The value in the Outer Window does not matter if you are just changing the setting.
4.
Press and hold the
Stop
button, then press the
+
and
–
buttons under
Diameter
.
You will hear a beep; the display changes from Inches to Millimeters.
5.
To tell which setting is active, look at the values in the Inner and Outer Windows:
–
If the values have decimal points, Inches are active.
–
If the values
do not
have decimal points, Millimeters are active.
Note
:
The Inches/Millimeters setting for Wheel Diameter is
not
saved if you restart the Balancer.
It resets to the default, Inches.
Important
: You must know what measurement system is active when you are entering
measurements. If you do not, you could enter a value in Inches when the Balancer is
set to Millimeters, or vice versa.
Toggling Auto Hood Start
By default, lowering the Hood starts a balancing session. This is a convenience feature, so you just
have to lower the Hood not lower the Hood and then press Start.
Important
: If the Hood is up, you cannot start a balancing session.
To disable Auto Hood Start if it is enabled, press Stop and then press the R button. You will hear a
beep. The setting has been changed.
To enable Auto Hood Start if it is disabled, press Stop and then press the R button. You will hear a
beep. The setting has been changed.
Note
:
The Auto Hood Start setting, whether enabled or disabled, is saved if you restart the
Balancer.
Summary of Contents for DST30P
