WARRANTY POLICY
Ranger Products™ are backed by over 35 years of
manufacturing experience. Every spray wash
cabinet bearing the Ranger™ name is sold with the
following warranty.
Each Ranger Product™ is warranted to be free
from defects in workmanship and material for a
period of one year from the date of shipment
provided that a written claim for such defect is
made within that time.
This warranty does not cover damage or defects
caused by carelessness of the operator, misuse,
abuse or abnormal use which in any way impairs the
proper functioning of the equipment or by the use or
addition of parts not manufactured by Ranger
Products™ or its suppliers.
THIS WARRANTY IS EXPRESSLY MADE IN LIEU OF
ANY AND ALL OTHER WARRANTIES EXPRESSED OR
IMPLIED INCLUDING THE WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
If your Ranger Products™ machine is not functioning
properly, call your Ranger Products™ dealer immediately.
On some occasions, an independent contractor may be
hired to do the repairs. Within the warranty period, a
customer should not hire his own contractor unless it is
authorized in writing by Ranger Products™.
If it is necessary to return equipment for repairs, your
dealer will so advise you. When returning equipment for
repairs, empty and thoroughly clean out the tank, see
that machines are properly crated and protected, and
prepay transportation.
Defective parts replaced at no charge must be returned
to your dealer or Ranger Products™ within 60 days of the
date that the replacement parts are shipped; otherwise,
you must pay for the replacement parts at the current
selling price.
PRECAUTIONS / DANGERS
Read this entire manual before attempting to install your
Ranger Products™ parts washer.
The heating element(s) and pump/motor can be
damaged if the water level drops too low. Check
the water level daily. The proper water level is when
there is 1’ of water visible in the filter basket. There
should always be water in the removable filter
basket, but it should be below the oil skimmer slot.
Clean the filter basket regularly so the water can
return to the holding tank.
Cleaning will be poor and the heating element(s) and
pump / motor may get damaged if the machine is not
cleaned according to instructions.
Your parts washer is made with mild steel and will
rust unless you use the correct detergent and follow
the correct start-up procedure. Make sure the brand
you are using is safe on mild steel and has an
adequate concentration of rust inhibitors. When
installing the unit, don’t fill the tank unless you have
the time needed to heat the water to 140-160F, add
the detergent, and run the wash cycle for at least
one (1) hour to coat the steel with rust inhibitor.
Again, read this entire manual before starting the
installation so that you know what is involved.
(See “Chemical Selection”)
Since laws and regulations are forever changing, and
since they often vary region to region, the remarks in
this section should only be construed as a general
guideline. It is your responsibility to research,
understand and follow the exact environmental
regulations of your region.
2
DANGER!
Your machine uses HIGH VOLTAGE electricity.
Obtain the services of a qualified electrician
for all electrical work.
DANGER!
Do not use any petroleum base chemical or
solvent, or any flammable products in your parts
washer.
