RML-1100
INSTRUCTIONS
UNPACKING AND SET-UP
1. Carefully open packaging and inspect the lift for
damage. Refer to drawing on page 7.
2. Place the Lift on a solid surface.
3. Assemble the Handle and place the Handle
Assembly over the Lifting Screw Head and turn clockwise
to raise lift slightly.
4. Slide both Saddle Assemblies (Items 4,5,6) over
Lifting Platform and tighten locking Bolts to secure.
NOTE:
Lift may be bolted to ground or a lift table.
(If approved by lift table manufacturer.)
OPERATION
1. Loads must be centered on table at all times.
2. Loads must be firmly positioned and securely loaded
on Saddle Assembly or platform at all times.
3. Adjust Saddle Assembly and Saddle Height to hit
vehicle lifting points. Saddles are adjustable.
Adjust Saddles so that there is a minimum
1/2” of threaded rod remaining in thread plate.
4. Slowly turn the Handle assembly clockwise to engage
vehicle lifting points and then lift vehicle slightly.
WARNING!
CHECK LOADING BY SLIGHTLY MOVING VEHICLE
TO CHECK IF VEHICLE IS PROPERLY SEATED
ON THE SADDLE OR PLATFORM BEFORE LIFTING
VEHICLE HIGHER. LOWER AND ADJUST LIFTING
POINTS IF REQUIRED.
5. Continue lifting to desired height.
6. Support vehicle with Jack Stands before beginning
work under the vehicle.
MAINTENANCE
1. When not in use, the lift must be stored in the lowest
position in a dry location.
2. Keep the lift clean and wipe off any oil or grease.
Lubricate all moving parts.
3. Before each use check all parts. If any part of the lift
is damaged or suspect, remove the lift from service and
take necessary action to repair.
4. All moving parts have been lubricated at the factory
and should be re-lubricated every (6) months to prevent
galling.
5. Lightly oil lifting screw (Item 8) when it becomes dry.
SPECIFICATIONS
Max. Capacity: 1100lbs / 500kg
Max. Height: 15-3/4” / 400mm
Min. Height: 3-3/4” / 95mm
Platform Size: 17-23/32” x 5-29/32”/ 450 x 150 mm
Shipping Weight: 30 lbs. / 13.7 kg.
CAUTION!
1. The maximum load is 1100lbs (500kg)
DO NOT
exceed this rated capacity.
2. Use this lift for second-lift purpose only.
DO NOT
use
it for any other purpose it is not designed to perform.
