Ranger Products Professional RFJ-3TP, Installation And Operation Manual, Page: 4 / 8

4
UPON DELIVERY
• Carefully remove all packaging material.
• Inspect the equipment and all parts for any signs of
concealed shipment or storage damages.
• Rememeber to report any shipping damage to the
carrier and make a notion on the delivery receipt.
IMPORTANT SAFETY TIPS
• Be sure to read all warning labels and the instruction
manual prior to operation of this equipment.
• Keep hands and body clear of all pinch points.
• Use the jack for loading under-rated capacity only.
DO NOT over load.
• Ensure the jack is set on a solid and level surface.
• Support the load with jack stands after the load is
raised to the desired level, before getting under the
load.
• Center the load on the jack saddle properly. An off
centered load may damage the seals and result in
jack failure.
• Lift only dead weight. Always set the hand brake and
block the wheels of the vehicle.
• This jack is to be used by professional personnel
only. In order to avoid a dangerous situation, please
ensure that non professional personnel and
specially CHILDREN DO NOT USE THIS JACK
under any circumstances.
THIS IS A LIFTING DEVICE ONLY. DO NOT MOVE OR
DOLLY THE VEHICLE WHILE ON THE JACK.
IMMEDIATELY AFTER LIFTING, SUPPORT THE
VEHICLE WITH APPROPRIATE MEANS.
DO NOT EXCEED RATED CAPACITY.
OVERLOADING CAN CAUSE DAMAGE TO
OR FAILURE OF THE JACK.
LIFT ONLY ON AREAS OF THE VEHICLE AS
SPECIFIED BY THE VEHICLE MANUFACTURER.
KEEP HANDS AND BODY CLEAR OF ALL PINCH
POINTS.
CENTER LOAD ON SADDLE PRIOR TO LIFTING.
OFF-CENTER LOADS MAY CAUSE DAMAGE TO
JACK, LOSS OF LOAD, PROPERTY DAMAGE,
PERSONAL OR FATAL INJURY.
THIS JACK IS DESIGNED FOR USE ONLY ON HARD
LEVEL SURFACES CAPABLE OF SUSTAINING THE
LOAD. USE ON OTHER THAN HARD LEVEL
SURFACES CAN RESULT IN JACK INSTABILITY AND
POSSIBLE LOSS OF LOAD.
NO ALTERATIONS TO THE JACK SHALL BE MADE.
READ, STUDY AND UNDERSTAND THE OPERATING
MANUAL PACKED WITH THIS JACK BEFORE
OPERATING.
FAILURE TO HEED THESE WARNINGS MAY RESULT
IN LOSS OF LOAD, DAMAGE TO JACK, AND/OR
FAILURE RESULTING IN PROPERTY DAMAGE,
PERSONAL OR FATAL INJURY.
ASSEMBLY INSTRUCTIONS
1. Insert handle assembly into Handle Socket and
tighten Bolt.
OPERATING INSTRUCTIONS
BEFORE USE:
1. Air may become trapped in the hydraulic system
during transit. To purge air:
2. Open release valve by pulling outward on the handle
and turning counter clockwise.
3. Pump Handle rapidly 6-8 strokes. This will expel air
that may have entered oil passages during transit.
4. Close release valve by twisting Handle clockwise
and pump handle.
5. If lift arm is raised, jack is ready for use. If not, just
repeat this procedure.