Rangemaster Toledo 110 Dual Fuel, User Manual, Page: 31 / 36

31
WARNING - SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
14. To Change Oven Door Outer Panel
Move the cooker forward to gain access to the sides.
Open the oven door slightly and remove the front panel
fi xing screws from the door top and bottom (A).
Carefully lift off the outer door panel.
Remove door handle from panel by unscrewing 2
retaining nuts. Fit door handle to new panel
Fit panel to door. Reassemble in reverse order.
15. To Change Oven Door Latch
Remove outer door panel (see 14). Remove screws
‘B’ holding latch assembly to inner door panel. Fit new
catch and reassemble in reverse order.
Check correct door operation.
16. To Adjust an Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fi t is
obtained. Retighten locking nut.
17. To Change Oven Door Seal
Open oven door. The seal is held in place by small
hooks on the rear face. At the corner pull seal diagonally
away from the door centre until that hook is released.
Proceed to the next hook and release it in a similar way,
and so on. Use force if the hooks are stiff, as the old
seal will be discarded.
When fi tting new seal, position the seal join at the
bottom. Hook the new seal in one of the corner holes of
the door, and proceed round the door snapping in each
hook in turn.
18. To Adjust Oven Door Catch Keep
Open oven door, slacken off locknut at base of keep,
and screw in or out as required until required fi t is
obtained. Retighten locking nut.
19. To Remove Grill Element.
Disconnect from electricity supply.
Remove grill pan from grill chamber. From inside grill
compartment remove enamelled front shield from
grill roof, 2 screws and washers. Remove 2 screws
and washers securing the grill element front support.
Remove the screws from the grill elements.
Lift elements out carefully, disconnect the leads from
the element terminals noting their position. If it is not
possible to disconnect the leads in this way, pull cooker
forward to gain access to the rear, remove screws
securing the electric cover to the back sheet and
remove cover and disconnect the terminals from the
rear.
Fit new elements, reassemble in reverse order. Check
operation of grill.