Rangemaster RMB45CFBL/SS, User Manual & Installation & Service Instructions, Page: 26 / 48

24
4. Cleaning and Maintenance
Essential Information
Allow the appliance to cool and isolate the electricity supply
before carrying out any thorough cleaning and maintenance.
n n
Never use paint solvents, washing soda, caustic
cleaners, biological powders, bleach, chlorine based
bleach cleaners, coarse abrasives or salt.
n n
DO NOT mix different cleaning products – they may
react together with hazardous results.
n n
Any abrasive cleaner will scratch the surface and
could erase the control panel markings. Stainless
steel can be effectively cleaned by simply using a
dilute solution of water and mild detergent and
drying to a shine with clean cloth.
Regular cleaning is recommended. For easier cleaning, wipe
away any spillages immediately.
Cleaning
n n
Disconnect the appliance from the power supply
before cleaning.
n n
Do not wash your appliance by pouring water on it.
n n
DO NOT use harsh abrasives, or aggressive cleaners
as these can damage the interior of the appliance.
n n
The appliance is heavy. When moving the appliance
be careful to protect the floor. Keep the appliance
vertical and do not tilt the appliance – this prevents
damage to the floor.
n n
DO NOT spray or rinse the appliance with water or
other liquids. This could harm the electrical parts.
n n
Use a dry cloth when cleaning near the electrical
parts (such as the light bulb or switch).
n n
DO NOT clean the appliance with a stiff or wire
brush.
n n
DO NOT use an organic solvent such as detergent,
petrol, lacquer, thinners, acetone or acid.
Clean the appliance using warm water and bicarbonate of
soda with a soft cloth. Make sure that the interior is then
dried carefully with a suitable cloth.
After washing, rinse with clean water and dry carefully. When
you have finished cleaning, reconnect the appliance to the
mains supply with dry hands.
Shelves and other accessories (plastic and glass parts) can be
cleaned in the sink using liquid dishwashing liquid and warm
water. Make sure all soap is rinsed off and all parts are dry
before replacing them inside the appliance.
Make sure that no water enters the electrical components.
The appliance should be cleaned regularly using a solution of
bicarbonate of soda and lukewarm water.
Clean the accessories separately by hand with soap and
water. DO NOT wash accessories in a dish washer.
Control Panel
Avoid using any abrasive cleaners, including cream cleaners,
on brushed stainless steel surfaces. For best results use a
liquid detergent.
The control panel, knobs and doors should only be cleaned
with a soft cloth wrung out in clean, hot soapy water. After
cleaning, polish with a dry cloth.