Rangemaster Nexus SE 110, User'S Manual & Installation Instructions

Page: 15 / 48

11
Residual Heat Indicator,
H
After use, a cooking zone will remain hot for a while as heat
dissipates. When a cooking zone is switched off the residual
heat indicator symbol [
H
], will appear in the display. This
shows that the cooking zone temperature is above 60 °C and
may still cause burns. Once the temperature has dropped to
below 60 °C the [
H
] will go out.
Child Lock,
IMPORTANT : The child lock can only be activated when all
the cooking zones are switched off.
To prevent the unwanted use by children, the hob can be
locked.
To lock the hob, simultaneously turn the two left-hand
controls counter-clockwise ( Fig. 2.6 ) and hold until the
symbol appears in the centre of the hob control display
( Fig. 2.7 ).
Locking the hob will
NOT
affect the oven; it can still be used.
To unlock the hob, simultaneously turn the two left-hand
controls counter-clockwise and hold until the symbol
disappears from the centre of the hob control display.
Low Temperature Setting,
L1/L2/L3
Each cooking area is equipped with 3 low temperature
settings:
•
L1
will maintain a temperature of about 44 °C – ideal for
gently melting butter or chocolate.
•
L2
will maintain a temperature of about 70 °C - ideal for
keeping food warm, once it is cooked.
•
L3
will maintain a temperature of about 94 °C – ideal for
simmering (bring the pan to the boil and then select
L3
to keep soups, sauces, stews, etc at an optimal simmer).
The maximum time this setting can be used is 2 hours. To
increase the heat, just turn the control knob to the required
level. The maximum times for all other power levels are
shown in Table 2.2 .
Power Boost Setting,
P
All of the induction cooking zones have Power Boost
available, activated by turning the control knob clockwise
until [
P
] is shown on the hob control display.
Power Boost allows additional power to be made available for
each of the cooking zones. This is useful to bring a large pan
of water to the boil quickly.
The Power Boost function operates for a maximum of 10
minutes on each zone, after which the power is automatically
reduced to setting
9
.
Deactivate the Power Boost function by turning the control
knob to a lower setting.
M
M
Fig. 2.6
Fig. 2.7
Power level Maximum operating time
L1
,
L2
and
L3
2 hours
1 6 hours
2 6 hours
3 5 hours
4 5 hours
5 4 hours
6 1.5 hours
7 1.5 hours
8 1.5 hours
9 1.5 hours
Power boost 10 minutes
Table 2.2