Rangemaster Longstock 110 Induction, User Manual

Page: 29 / 44

25
The oven light is not working
The bulb has probably blown. You can buy a replacement bulb
(which is not covered under the guarantee) from most electrical
stores. Ask for a 40 W – 230 V halogen lamp (G9) (
Fig. 7.1
).
Before removing the existing bulb, turn off the power supply
and make sure that the oven is cool. Open the oven door and
remove the oven shelves.
Locate the bulb cover and unscrew it by turning it counter-
clockwise – it may be very stiff (
Fig. 7.2
).
Pull the existing bulb to remove it. When handling the
replacement bulb, avoid touching the glass with your fingers,
as oils from your hands can cause premature failure. Push,
click in the replacement bulb.
The oven door is misaligned
The bottom hinge of either oven door can be adjusted to
alter the angle of the door ( Fig. 7.3 ). Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position ( Fig. 7.4 ).
The oven is not cooking evenly
Do not use a baking tray with dimensions larger than those
specified in the section on ‘General Oven Tips’.
If you are cooking a large item, be prepared to turn it round
during cooking.
If two shelves are used, check that space has been left for
the heat to circulate. When a baking tray is put into the oven,
make sure that it is placed centrally on the shelf.
Check that the door seal is not damaged and that the door
catch is adjusted so that the door is held firmly against the
seal.
A dish of water when placed on the shelf should be the
same depth all over. (For example, if it is deeper at the back,
then the back of the cooker should be raised up or the front
lowered.) If the cooker is not level, arrange for your supplier
to level it for you.
Power failure
In the event of a failure in the electrical supply, remember to
reset the clock so that the timed oven continues to operate.
The timed oven is not coming on when turned on
manually
Is the power on? Is the clock illuminated? If not, there may be
something wrong with the power supply. Is the cooker supply
on at the isolator switch?
Has the time of day been set?
The timed oven is not coming on when automatic
cooking
Has the oven knob been left in the OFF position by mistake?
Fig. 7.1
Fig. 7.2
ArtNo.320-0006 Oven door hinge adjustment 1
Effect of hinge adjustment – exagerrated for clarity
ArtNo.320-0007 Oven door hinge adjustment 2
Centreline of hinge pin
Oven door omitted for clarity
Fig. 7.3
Fig. 7.4