Rangemaster Kitchener 100 Ceramic, User'S Manual & Installation Instructions

Page: 32 / 44

28
INSTALLATION
Check the appliance is electrically safe when you have finished.
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability
bracket
Floor
Stability
location
bracket
Wall
Typical wall mounting
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
Stability
location
bracket
Typical floor mounting
Alternative positions
for stability location
bracket
ArtNo.010-0004 Moving the cooker
Lowering the two rear rollers
To adjust the height of the rear of the cooker, first fit a 13 mm
spanner or socket wrench onto the hexagonal adjusting nut
(
Fig. 11.5
).
Rotate the nut – clockwise to raise – counter-clockwise to
lower. Make 10 complete (360°) turns clockwise.
Make sure you lower BOTH REAR ROLLERS.
Completing the move
Unfold the rear edge of the cardboard base tray. Open the
grill door and right-hand oven door so that you can get a
good grip on the bottom of the fascia panel as you move the
oven (
Fig. 11.6
).
Carefully push the cooker backwards off the base tray.
Remove the base tray.
Position the cooker close to its final position, leaving just
enough space to get behind it (
Fig. 11.7
).
n
DO NOT use the door handles or control knobs to
manoeuvre the cooker.
Fitting the stability bracket
The cooker must be secured with a suitable stability device.
The device is shown in
Fig. 11.8
,
Fig. 11.9
and
Fig. 11.10
.
Attach the bracket location device to the rear of the cooker
( Fig. 11.8 ). Then adjust the bracket to engage through the
slot of the device ( Fig. 11.9 and Fig. 11.10 ).
Repositioning the cooker following
connection
If you need to move the cooker once it has been connected,
make sure it is switched off at the supply switch before
gripping under the fascia panel and lifting the front of the
cooker slightly ( Fig. 11.6 ). Check behind the cooker to make
sure that the electricity cable is not caught.
As you progress, always make sure that the cable has
sufficient slack to allow the cooker to move.
When you replace the cooker, check behind it again once
more to make sure that the electricity cable is not caught or
trapped.
Fig. 11.5
Fig. 11.6
Fig. 11.7
Fig. 11.8
Fig. 11.9
Fig. 11.10