Rangemaster INC110DFFBL, User'S Manual & Installation Instructions

Page: 26 / 44

22
Oven light is not working
The bulb has probably burnt out. You can buy a replacement
bulb (which is not covered under the warranty) from a good
electrical shop. Ask for a 40 W – 230 V halogen lamp (G9)
(Fig. 8.1).
Turn off the power at the circuit breaker.
Before removing the existing bulb, turn off the power supply
and make sure that the oven is cool. Open the oven door and
remove the oven shelves.
Unscrew the bulb cover by turning counter-clockwise. It may
be very stiff (Fig. 8.2).
Pull the existing bulb to remove it. When handling the
replacement bulb, avoid touching the glass with your fingers,
as oils from your hands can cause premature failure. Push,
click in the replacement bulb.
The oven door is misaligned
The bottom hinge of either oven door can be adjusted to
alter the angle of the door (Fig. 8.3). Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig. 8.4).
Retighten the hinge screws.
Grill
The fascia gets hot when I use the oven or grill
The cooker is cooled by a fan. If the fascia becomes
excessively hot when the cooker is in use then the cooling
fan may have failed. Should this occur please contact your
installer, a qualified repair engineer or Customer Service to
arrange for its repair.
The knobs get hot when I use the oven or the grill. Can I
avoid this?
Yes, this is caused by heat rising from the oven and heating
them up. DO NOT leave the oven door open.
Make sure that the grill pan is pushed right back to the ‘back
stop’ when grilling.
Always grill with the grill compartment door open.
Grill is not cooking properly
Are you using the pan and trivet supplied with the cooker?
Is the pan being used on the runners, not the floor of the grill
compartment?
Is the grill tray pushed back fully to the stop?
ArtNo.320-0007 Oven door hinge adjustment 2
Effect of hinge adjustment – exaggerated for clarity
Oven door omitted for clarity
Centre line of hinge pin
Fig. 8.1
Fig. 8.2
Fig. 8.3
Fig. 8.4