Rangemaster ECL6013PBLG/C, User Manual & Installation & Service Instructions, Page: 23 / 36

21
IMPORTANT
n
Never use screwdrivers or other utensils to remove
the light cover. This could damage the enamel of the
oven or the lamp holder.
n
Remove only by hand.
n
Never replace the bulb with bare hands as
contamination from your fingers can cause
premature failure. Always use a clean cloth or
gloves.
n
Please note: The bulb replacement is not covered
by your guarantee.Positioning the oven trays and
shelves
The baking Tray, Grill Tray or Oven Shelf can be located in any
of the five height positions in the oven.
When fitting the trays or shelves, ensure they are fitted
between the two wires that are the closest (
Fig. 6.8
).
Removing the side runners
1.
Check the oven is cool and switched off.
2. Open the oven door.
3.
Remove all shelves (
Fig. 6.9
).
4. Slightly squeeze the bottom two row of the runner
under the screw ( Fig. 6.9 ).
5.
Whilst squeezing the bottom two row, pull the runner
away from the side of the oven chamber (
Fig. 6.9
).
6. To fit the runners follow the steps in reverse order.
Glide-out Oven Shelves
The glide-out shelves slides out like a drawer, allowing you
to tend to the food safely and quickly. The pan can easily be
removed.
To fit the glide-out runners
Hook the rear of the runner (
Fig. 6.10
) over the top rung of a
pair of shelf supports. Then hook the front of the runner onto
the same rung. Push to clip under the bottom rung
(
Fig. 6.11
).
Ensure that the shelf runners are fitted in the same position
on each side ( Fig. 6.13 ).
To remove the glide-out runners
Twist to unclip the base of the runners from the shelf
supports. Then unhook the runner from the top rung of the
shelf support and remove ( Fig. 6.12 ).
n
DO NOT put the glide-out shelf runners in a
dishwasher.
Fig. 6.8
Fig. 6.9
Fig. 6.10
1
2
2
1
Fig. 6.11 Fig. 6.12
Fig. 6.13