2
Undermount sink
CRUB3314WH/ (
Fig. 1.3
)
CRUB3216WH/ (
Fig. 1.4
)
CRUB4040WH/ (
Fig. 1.5
)
CRUB5340WH/ (
Fig. 1.6
)
CRUB385WH/ (
Fig. 1.7
)
CRUB1740WH/ (
Fig. 1.8
)
•
To ensure perfect positioning of the product, the cutout
details are shown below. The cutout template is also
available online www.rangemaster.co.uk.
•
The height of the shelf should be such that when the
sink is placed on the shelf the top face rim of the sink is
level with the underside face of the worktop, see (
Fig.
1.9
) and (
Fig. 1.10
).
Installation
IMPORTANT
: Due to the larger dimensional tolerances on
ceramic products we strongly recommend making the cut
out in a scrap piece of material then checking it against the
actual sink to be fitted. The cut out size should be adjusted
to suit the sink tolerances and retested against the intended
product before committing to cutting the final worksurface.
The ‘nominal’ suggested cut out size will align the cut out
edge with the bowl edge radius. The offset from the bowl can
be adjusted to overhang or be set back according to personal
taste but, this may interfere with installation or the correct
usage of sink accessories.
Note
: If the cut out is adjusted to either overhang or set back
from the sink rim, sufficient surface area must be left to allow
a water tight seal.
Fig. 1.10
shows the cut out flush to the
bowl radius.
Please do not over tighten any fittings as this may cause the
surface of your ceramic sink to crack.
1.
Install the tap to the worktop according to the
manufacturer’s instructions. Ensure the tap is secure as
later access may be obstructed by the sink or plumbing.
We recommend using long flexible tap connectors to
help.
2.
Install the basket strainer waste kit(s) and overflow
according to the manufacturer’s instructions.
3.
Clean the cut out perimeter of the worktop underside
and the upper perimeter of the sink with a degreasing
cleaning solvent and allow to dry.
4.
Apply a continuous generous bead of good quality
silicone onto the rim around the upper perimeter of the
sink (
Fig. 1.9
) or (
Fig. 1.18
).
5.
Gently lay the worksurface onto the sink, carefully align
the sink rim with the cut out shape with equal spacing
on all sides (
Fig. 1.10
).
Where possible apply a 2nd and 3rd bead of silicone around
inside and outside of the adjoining sink and worktop. Any
excess silicone can be cleaned away using a proprietary
silicone cleaner. Allow the silicone to dry.
6.
Attach the sink connecting pipework to the waste kit(s)
according to the manufacturer’s instructions.