Rane AC 22, Operating And Service Manual

Page: 11 / 27

AC 23 2-Channel 3-Way Installation
Observe the labels ABOVE the inputs and output for 2-channel operation.
1. CHANNEL 1 INPUT: Use this input only if you are running true stereo: two separate
channels from the mixer or other source. Connect this input to the left channel output of the
mixer, equalizer or other signal source. If you are running two speaker systems from a single
mono signal, omit this input and use only the Channel 2 input. See #2 below.
2. CHANNEL 2 INPUT: For true stereo operation, connect this input to the right channel
output of the mixer, equalizer or other signal source. NOTE: Two separate speaker systems
may be independently operated from a single mono source by using only the Channel 2 input
and omitting the Channel 1 input. As long as nothing is plugged into the Channel 1 input,
Channel 2 will drive BOTH channels of the AC 23 internally, eliminating the need for an
external "Y" adapter.
3. HIGH FREQUENCY OUTPUTS: Connect the Channel 1 High Out to the left channel
input of the high frequency amplifier, and the Channel 2 High Out to the right channel input of
the high frequency amp.
4. MID FREQUENCY OUTPUT: Connect the Channel 1 Mid Out to the left channel of the
mid frequency amplifier, and the Channel 2 Mid Out to the right channel of the mid amp.
5. LOW FREQUENCY OUTPUTS: Connect the Channel 1 and 2 Low Outs to the left and
right channels of the low frequency amplifier, respectively.
6. AC POWER LINE CORD: Plug this into a 120 VAC wall outlet
I
7. EXTERNAL POWER JACK: Use only with Rane RS 10 Power Supply (See Rane Note 118 for
details). Cannot be used to power other units. -WARN I NG: DO NOT PLUG ANY TYPE OF
TELEPHONE EQUIPMENT TO THIS JACK.-
10