present while closing function disabled. If you wish to enable
the function, proceed as follows: check that the extended menu
2 is enabled (flagging by 1110-1110-1110.. flashing T. PAUSE
LEDs start flashing simultaneously), use the SEL button to
navigate to the LAMP/CORT LED when flashing and press the
SET button: the LAMP/CORT LED remains lit in a constant
manner and programming is complete. In this manner the
control unit while operate in User present while closing mode.
The input controls for Ascent (P = Step by step) and Descent
(D.S. = User present) will be modified with the Normally Open
operation.
Repeat the operation if wanting to restore the previous
configuration.
D) T. MOT. (Not Used):
RESET :
To reset the default configuration of the control unit, press the
SEL and SET buttons simultaneously; all RED indicator LEDs
will switch on and then off again immediately.
INSTALLER ACTIVATION MODE:
In case of maintenance of the alarm system, it is necessary to
Activate the installer mode in order to deactive de alarm system
And the Tampere control input, if you wish this mode, proceed
as Follows: disconnect and reconnect the 230 Vac supply line
to the Unit, keeping pushing for at least 10 seconds the
memorized CODE ALARM Button of the radio control, at the
same time You get a short flash of all the leds and the
simultaneous Activation of Lamp light output for 3 seconds, so
the programming Is done. Automatically the installer mode is
deactivated at the First cycle of normal functioning of frame or
at the activation of the Alarm system.
DIAGNOSTICS :
In correspondence to each low voltage input command, the
control unit uses LED signals allowing rapid status control.
Functioning logic: a lit LED means input closed, an unlit LED
means input open.
MANAGEMENT OF PROGRAMMING LEDS:
After 3 minutes of inactivity during the programming, the unit
Automatically turns off the programming leds for saving energy.
With a pressure of SEL or SET buttons, or a moving delivery
Command, the LEDs will turn on, basing on memorized
Programming.
Summary of Contents for LRX 2035
Page 6: ...Rev 1 2 date 21 04 2015...
