Basic Operation
R&S
®
ZNH
38
User Manual 1334.5985.02 ─ 02
"Config Overview" block
Corresponding dialog box
Description
Select "Amplitude" to configure
the parameters related to the
tical axis (Range, Reference
Leve, Scale)
"Trace" ("Trace1", "Trace2",
"Trace3", "Trace4"). To couple the
vertical axis settings of different
traces, select the "Coupled
Traces" for configuration.
You can also select the "Port
Power" and "Rcv Att Port 1/2" to
adjust the port power and receiver
attenuation of the instrument. To
adjust "Port Power" above -5
dBm, the "Range" should be set
to "Maximum". By default, "Lev-
eled" is set for "Range".
See
Select "Analysis" to determine the
number of measurement points
trace measurement mode.
●
If "AVG" is configured as
"Average", the field "Avg
Count" is available for config-
uration.
●
If "Smoothing" is set "On",
the R&S
ZNH suppress sig-
nals resulting from interfering
sources and the "Aperture" is
available for configuration.
●
If "Aperture" is set to "Man-
ual", the R&S
ZNH turns
automatic aperture calcula-
tion off. The default aperture
size is 1.
See
4.2
Configuring the R&S
ZNH
In the "Instrument Setup" dialog box, the R&S
ZNH provides various general settings
that are independent of the operating mode of the R&S
ZNH.
1. Press [SETUP] key.
2. Select "Instrument Setup" softkey.
A corresponding dialog box to configure the instrument opens.
3. Select the item you want to modify.
Configuring the R&S
ZNH