R&S ZNH, User Manual

Page: 217 / 369

Remote Commands
R&S
®
ZNH
210 User Manual 1334.5985.02 ─ 02
Prevents servicing of the subsequent commands until all preceding commands have
been executed and all signals have settled (see also command synchronization and
*OPC
).
Usage: Event
12.6.2 Remote Commands of the Vector Network Analyzer
This section provides a detailed description of all remote control commands required to
configure and perform measurements in Vector Network Analyzer (VNA) mode.
● Configuring the Horizontal Axis .............................................................................210
● Configuring the Vertical Axis ................................................................................. 211
● Setting the Bandwidth ........................................................................................... 218
● Performing and Triggering the Measurements ......................................................218
● Working with Traces ..............................................................................................221
● Using Markers and Deltamarkers ..........................................................................223
● Configuring and Using Measurement Functions ...................................................224
12.6.2.1 Configuring the Horizontal Axis
Commands independent of the operating mode
Note that some of the commands for configuring the horizontal axis are also valid for
other operating modes. If a command is available in another mode, it is indicated by
the list in the respective section.
List of commands
The following commands configure the horizontal (frequency) axis of the active display.
●
[SENSe:]FREQuency:CENTer
on page 238
●
[SENSe:]FREQuency:CENTer:STEP
on page 238
●
[SENSe:]FREQuency:CENTer:STEP:LINK
on page 238
●
[SENSe:]FREQuency:SPAN
on page 238
●
[SENSe:]FREQuency:SPAN:FULL
on page 239
●
[SENSe:]FREQuency:STARt
on page 239
●
[SENSe:]FREQuency:STOP
on page 239
For a detailed description of the commands, see Configuring the Horizontal Axis in
CAT mode.
Remote Control - Commands