Safety Instructions
R&S
®
ZN-Z103
4
User Manual 1321.2276.02 ─ 02
Scope of this document
This User Manual gives a brief introduction to the unit’s connection and use.
For detailed information refer to the operating manual or help system of
your network analyzer.
2
Safety Instructions
This calibration unit has been designed and tested in accordance with the EC
Certificate of Conformity and has left the manufacturer’s plant in a condition fully
complying with safety standards.
General safety considerations
To maintain this condition and to secure safe operation, you must observe
all instructions and warnings given in this manual and in the user manual of
the Rohde & Schwarz network analyzer.
3
Connecting the Calibration Unit
The calibration unit is designed for a direct USB connection to a network ana-
lyzer, primarily of the R&S
®
Cable Rider ZPH family.
Analyzers of the R&S
®
ZNx family with firmware version 2.80 or higher also
support the calibration unit.
The calibration unit provides the following connectors:
●
A mini-B USB connector
This is used to power-supply and control the unit. A USB cable for connection
to the network analyzer is provided with the calibration unit.
