![background image](http://html1.mh-extra.com/html/rands/spycerbox-cell/spycerbox-cell_hardware-manual_3082033010.webp)
Introduction
Safety Instructions
1-4
SpycerBox Cell | Hardware Guide | Version 1.0
Rohde & Schwarz DVS GmbH
1.3 Safety
Instructions
To use the SpycerBox Cell correctly please heed the following:
General
The SpycerBox Cell has been built according to the applying safety reg-
ulations. To minimize the possibility of a faulty operation of the device
all manuals and guides must be available at all times at the operation
site. Before installing and/or using the R&S system the manuals and
guides delivered with it must be read and observed.
Use the R&S system only in apparent good technical order.
The hardware of the R&S system works with voltages that can be
hazardous to your health. Never work on the system or access its
interior with the power cable(s) being plugged in. Make sure the
power supply is disconnected from the components you intend to
work on.
Computer hardware contains components that are sensitive to elec-
trostatic discharge. If you touch them without precautionary mea-
sures, they can be destroyed. Use a wrist strap connected to
ground when accessing electronic parts and take care of grounding
the system. Avoid touching the internal components of the R&S
system whenever possible.
Computer hardware contains components that are sensitive to
changing voltages. Connecting or disconnecting the R&S system
to or from peripheral hardware while any of them is switched on
may damage the hardware. Switch off all peripheral hardware
before connecting or disconnecting anything.
Use, store and transport the R&S system only in compliance with
the technical data laid out in section “Technical Data” on page A-5.
If fluids or solid objects get inside the casing, the R&S system must
be disconnected from the power supply immediately. Before using
the R&S system again, it has to be checked by authorized service
personnel.
Only use a damp tissue without any cleaning agents to clean the
casing.
The R&S system must not be misused, abused, physically dam-
aged, neglected, exposed to fire, water or excessive changes in the
climate or temperature, or operated outside maximum rating.
Noncompliance with safety instructions
If the R&S system is not used in compliance with the safety instruc-
tions, the warranty and all resulting liability claims will be void.
Please read the following safety instructions carefully be-
fore attempting any installation and/or performing any work
on the SpycerBox Cell hardware.