Instrument Tour
R&S
®
SMW200A
43
Getting Started 1412.9220.02 ─ 21
T/M/C
Multipurpose input/output trigger/marker/clock connectors.
The number of connectors depend on the installed baseband options:
●
Standard baseband generator (R&S
SMW-B10):
One T/M/C and two T/M connectors per board.
●
Wideband baseband generator (R&S
SMW-B9):
One T/M/C and one T/M connectors per board
The input/output signal has to be defined. The
the local connectors in the default instrument state.
Table 5-9: Default configuration of the T/M/C connectors (standard baseband)
T/M/C connector
(Standard baseband)
Direction
Default assigned
signal
Remark
1, 4
Output
Clock
Local clock signal for the par-
ticular baseband
2, 5
Input
Trigger
Local trigger signal for the
particular baseband
3, 6
Output
Marker 3
Marker output signal from the
particular baseband
Table 5-10: Default configuration of the T/M/C connectors (wideband baseband)
T/M/C connector
Direction
Default assigned signal
1
Output
Symbol clock
2
Input
External serial data
A dedicated LED indicates the connector status:
●
Green: an input connector
●
Yellow: an output connector
●
No light: the connector is not active
See also chapters "Data, Clock and Control Signals and Sources in the Base-
band" and "Local and Global Connectors" in the user manual.
DIG I/Q
Connectors for the input/output of a digital I/Q signal from and to a
Rohde
&
Schwarz instrument, like a signal generator, signal analyzer, the R&S
EX-IQ-BOX, or the R&S
®
CMW500.
The interfaces require the options listed in
sheet).
Rear Panel Tour
