Remote-Control Commands
Satellite Navigation
380
User Manual 1178.6379.02 ─ 01
[:SOURce<hw>]:BB:GNSS:STReam<st>:STATe
...............................................................380
[:SOURce<hw>]:BB:GNSS:STReam<st>:RFBand
.............................................................380
[:SOURce<hw>]:BB:GNSS:STReam<st>:ANTenna
........................................................... 380
[:SOURce<hw>]:BB:GNSS:STReam<st>:VEHicle
............................................................. 380
[:SOURce<hw>]:BB:GNSS:VEHicle:COUNt
......................................................................381
[:SOURce<hw>]:BB:GNSS:SV:SELection:REFerence:VEHicle
........................................... 381
[:SOURce<hw>]:BB:GNSS:STReam<st>:STATe
<State>
Activates the stream.
Parameters:
<State>
0 | 1 | OFF | ON
*RST:
0
Example:
See
Example "Multi-band GNSS signal"
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:STReam<st>:RFBand
<RFBand>
Selects the signal of which RF band is carried by which stream.
Parameters:
<RFBand>
L1 | L2
*RST:
L1
Example:
See
Example "Multi-band GNSS signal"
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:STReam<st>:ANTenna
<Antenna>
Selects the signal of which antenna is carried by which stream.
Parameters:
<Antenna>
A1 | A2
*RST:
A1
Example:
See
Example "Multi-antenna receiver"
Manual operation:
See
[:SOURce<hw>]:BB:GNSS:STReam<st>:VEHicle
<Vehicle>
Selects the signal of which vehicle is carried by which stream.
Parameters:
<Vehicle>
V1
*RST:
V1
Example:
See
Example "Multi-antenna receiver"
Advanced Mode Commands