R&S SMW-K44, User Manual

Page: 21 / 455

Getting Started Satellite Navigation
21 User Manual 1178.6379.02 ─ 01
5 Getting Started
In its default configuration, this software generates GNSS signal that is sufficient for a
receiver to get a position fix.
The simulated GNSS system depends on the installed options. For instance, if
R&S
SMW-K44 is installed, it is GPS C/A signal in the L1 band.
For any of the GNSS systems, the simulation starts on 19.02.2014 at 6 am UTC time
and satellite constellation corresponds to the one seen by a static receiver located in
Munich.
● Trying Out the GNSS Simulator ..............................................................................21
● General Settings ..................................................................................................... 23
● Simulation Monitor .................................................................................................. 26
5.1 Trying Out the GNSS Simulator
The following simple examples can help you get familiar with the basic functions of the
software:
●
"How to generate a GNSS signal for simple receiver tests (default configuration)"
on page 21
●
"How to configure a hybrid satellite constellation" on page 22
How to generate a GNSS signal for simple receiver tests (default configuration)
1. Select "Baseband > Satellite Navigation > GNSS".
2. Select "General > State > On".
The summary information confirms that a single GNSS system signal is generated.
The used frequency band is indicated, too.
3. To observe current satellite constellation, select "GNSS > Simulation Monitor".
Trying Out the GNSS Simulator