R&S SMJ100A, Operating Manual

Page: 817 / 874

Remote Control Commands
R&S
®
SMJ100A
801 Operating Manual 1403.7458.32 ─ 14
:SYSTem:MMEMory:PATH:USER?
Queries the user directory, that means the directory the instrument stores user files on.
Return values:
<PathUser> string
Example:
SYSTem:MMEMory:PATH:USER?
Response: "D:\user\
Usage: Query only
7.19 TEST Subsystem
The TEST system contains the commands for performing the routines as well as for
direct manipulation of the hardware assemblies (
:TEST:DIRect
).
The self tests return a "0" if the test is performed successfully, otherwise a value other
than "0" is returned. None of the commands of this system have an
*RST
value.
Improper use may destroy the assembly!
The respective hardware assembly responds directly to the
:TEST:DIRect
command;
any safety mechanisms are bypassed. The command is used for servicing purposes
and should not be applied by the user.
:TEST:BB:CONNection?
................................................................................................. 801
:TEST<hw>:BBOut:LRATe
..............................................................................................801
:TEST<hw>:BBOut:TTESt[:STATe]
..................................................................................802
:TEST:CONNector:AUXio?
..............................................................................................802
:TEST<hw>:DIRect
........................................................................................................ 802
:TEST:BB:CONNection?
Queries the state of the connection between connectors USER1 and USER2.
A
0
=
PASS
response indicates that the conncetion is established, whereas a response
1
=
FAIL
stands for a faulty connection.
Return values:
<Connection> 0 | 1 | PASS | FAIL
Usage: Query only
Manual operation: See "Execute Baseband Connection Selftest" on page 139
:TEST<hw>:BBOut:LRATe <LRate>
The command sets the interface speed.
TEST Subsystem