Remote Control Commands
R&S
®
SMJ100A
779
Operating Manual 1403.7458.32 ─ 14
Manual operation:
See
"Dwell Time - Frequency Sweep"
[:SOURce<hw>]:SWEep[:FREQuency]:EXECute
Starts an RF frequency sweep cycle manually.
The command is only effective in single mode.
Example:
TRIG:FSW:SOUR SING
SOUR:SWE:FREQ:MODE AUT
SWE:FREQ:EXEC
triggers a frequency sweep at the RF output.
Usage:
Event
Manual operation:
See
"Execute Single Sweep - Frequency Sweep"
[:SOURce<hw>]:SWEep[:FREQuency]:MODE
<Mode>
Sets the sweep mode.
The keyword
[:FREQuency]
can be omitted (see example). The command is then
SCPI-compliant.
Parameters:
<Mode>
AUTO | MANual | STEP
AUTO
Each trigger triggers exactly one complete sweep.
MANual
The trigger system is not active. Each frequency step of the
sweep is triggered individually, either by varying the "Current
Frequency" value using the rotary knob under manual control or
by means of a
FREQ:MAN
command under remote control. With
manual control, the frequency increases or decreases (depend-
ing on the direction of the rotary encoder) by the value specified
under
FREQ:STEP:INCRement
. With remote control, the fre-
quency is set directly with the command
:FREQ:MAN
.
STEP
Each trigger triggers one sweep step only (Mode Single Step).
The frequency increases by the value entered under
SOUR:SWE:FREQ:STEP:LIN
(linear spacing) or
...:STEP:
LOG
(logarithmic spacing).
*RST:
AUTO
Example:
SWE:MODE AUTO
selects
Mode Auto
for a frequency sweep at the RF output.
Manual operation:
See
SOURce Subsystem
Summary of Contents for SMJ100A
