R&S SMJ100A, Operating Manual

Page: 786 / 874

Remote Control Commands
R&S
®
SMJ100A
770 Operating Manual 1403.7458.32 ─ 14
Parameters:
<Increment> float
Range:
full specified level range
Increment: see the data sheet: Level sweep > Step size setting
resolution
*RST: 1
Example: POW:STEP 2
sets the step width for entering the RF level to 2 dB.
Manual operation: See "Variation Step" on page 219
[:SOURce<hw>]:POWer:STEP:MODE <Mode>
Activates (
USER
) or deactivates (
DECimal
) the user-defined step width used when
varying the level value with the level values
UP/DOWN
. The command is linked to set-
ting "Variation Active" for manual control, i.e. the command also activates/deactivates
the user-defined step width used when varying the level value with the rotary knob.
Parameters:
<Mode> DECimal | USER
*RST:
DECimal
Example: POW:STEP 2
sets the step width for the level setting to 2 dB.
POW:STEP:MODE USER
actives this step width for level variation with the rotary knob
(manual control) and with level values
UP/DOWN
(remote con-
trol).
Manual operation: See "Variation Active" on page 219
[:SOURce<hw>]:POWer:STOP <Stop>
Sets the stop level for the RF sweep.
Note: You can select any level within the setting range. The range is defined by the
[:
SOURce<hw>]:POWer:STARt
value and this stop value.
A defined offset (
[:SOURce<hw>]:POWer[:LEVel][:IMMediate]:OFFSet
)
affects the level values according to the formula:
Minimum level + OFFSet ... Maximum level + OFFSet
Parameters:
<Stop> float
Determines the last level value of the sweep setting range.
Range:
full specified level range
Increment: see the data sheet: Level sweep > Step size setting
resolution
*RST: -10
SOURce Subsystem