R&S SMJ100A, Operating Manual

Page: 701 / 874

Remote Control Commands
R&S
®
SMJ100A
685 Operating Manual 1403.7458.32 ─ 14
[:SOURce<hw>]:BB:MCCW:TRIGger:SLENgth <SLength>
Sets the length of the signal sequence to be output in the "Single" trigger mode. The
input is to be expressed in samples. It is then possible to output deliberately just part of
the waveform, an exact sequence of the waveform, or a defined number of repetitions
of the waveform.
Parameters:
<SLength> integer
Range:
1 to 1000
*RST: 1
Example: SOURBB:MCCW:SEQ SING
sets trigger mode Single.
SOURBB:MCCW:TRIG:SLEN 200
sets a sequence length of 200 samples. The first 200 samples of
the current waveform will be output after the next trigger event.
Manual operation: See "Signal Duration" on page 432
[:SOURce<hw>]:BB:MCCW:TRIGger:SOURce <Source>
Selects the trigger source.
Parameters:
<Source> INTernal|BEXTernal|EXTernal
INTernal
manual trigger or
*TRG
.
EXTernal|BEXTernal
trigger signal on the TRIGGER 1/2 connector.
*RST:
INTernal
Example: SOURce1:BB:MCCW:TRIGger:SOURce EXTernal
sets external triggering via the TRIGGER 1 connector.
Manual operation: See "Trigger Source" on page 433
[:SOURce<hw>]:BB:MCCW:TRIGger[:EXTernal<ch>]:DELay <Delay>
Specifies the trigger delay (expressed as a number of samples) for external triggering.
Parameters:
<Delay> float
Range:
0 to 65535
Increment: 0.01
*RST:
0
Example: BB:MCCW:TRIG:SOUR EXT
selects an external trigger
BB:MCCW:TRIG:DEL 200
sets a delay of 200 samples for the trigger.
SOURce Subsystem