R&S SMJ100A, Operating Manual

Page: 533 / 874

Remote Control Commands
R&S
®
SMJ100A
517 Operating Manual 1403.7458.32 ─ 14
:BLER:SETup:MCOunt <MCount>
:BERT:SETup:MCOunt <MCount>
Enters the number of transmitted data bits/data blocks to be checked before the mea-
surement is terminated. With a BER measurement, data that was suppressed by
BERT:SETup:DENable
is not counted. This termination criterion always terminates
the measurement after the specified number of data bits/data blocks. Starting from this
point, the fourth value is output with 1 (= terminate measurement) if the result is quer-
ied with
:BERT|BLER:RES
. If the continuous measurement mode (
BERT|BLER:SEQ
AUTO
) has been selected, the measurement is restarted once the results have been
queried.
Parameters:
<MCount> integer
Range:
0 to 4294967295
*RST: 1E7
Example: BERT:SET:MCO 1E6
sets a measurement over 1000000 data bits.
Example: BLER:SET:MCO 1E3
sets a measurement over 1000 data blocks.
Manual operation: See "Max Data Bits" on page 189
:BLER:SETup:MERRor <MError>
:BERT:SETup:MERRor <Merror>
Enters the number of errors to occur before the measurement is terminated. This termi-
nation criterion always terminates the measurement after the specified number of
errors. Starting from this point, the fourth value is output with 1 (= terminate measure-
ment) if the measurement result is queried with
:BERT|BLER:RES
.
Parameters:
<Merror> integer
Range:
0 to 4294967295
*RST: 100
Example: BERT:SET:MERR 1E4
sets a measurement over 1000 errors.
Manual operation: See "Max Errors" on page 189
:BERT:SETup:RESTart[:STATe] <State>
Activates/deactivates an external restart of the BER measurement.
Parameters:
<State> INTernal | EXTernal
*RST:
INTernal
Example: BERT:SET:REST:STAT INTernal
The external signal restarts the measurement.
BERT and BLER Subsystems