R&S SMJ100A, Operating Manual

Page: 444 / 874

Instrument Function
R&S
®
SMJ100A
428 Operating Manual 1403.7458.32 ─ 14
Desired Crest Factor
Enters the desired crest factor.
This is only possible when the optimization "Target Crest" has been selected.
Remote command:
[:SOURce<hw>]:BB:MCCW:CFACtor
on page 677
Table Setup Assistant
The "Table Setup Assistant" section can be used to set a selectable carrier range. The
carrier table can be edited in the "Carrier Table" dialog.
Carrier Start
Defines the start index of the carrier range to which the following settings are intended
to apply.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt
on page 681
Carrier Stop
Defines the stop index of the carrier range to which the following settings are intended
to apply.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP
on page 681
Carrier State
Switches the carriers in the carrier range on/off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe
on page 681
Power Start
Sets the power of the starting carrier.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt]
on page 681
Power Step
Sets the width of the step with which the power will be changed from carrier to carrier.
The carrier power that is set with Power + n* Power Step must be within the valid
value range -80 dB to 0 dB.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer:STEP
on page 680
Phase Start
Sets the phase of the starting carrier. This setting is only available for "Optimize Crest
Factor Mode" = Off.
Remote command:
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:PHASe[:STARt]
on page 680
Baseband Signal - Baseband Block