R&S SMJ100A, Operating Manual

Page: 218 / 874

Instrument Function
R&S
®
SMJ100A
202 Operating Manual 1403.7458.32 ─ 14
RF Freq
Enters the RF frequency, considering the frequency offset.
Note: The SCPI command sets the level of the "Freq" display, that means an entered
frequency offset and multiplier factor are taken into consideration in the frequency
value.
Remote command:
[:SOURce<hw>]:FREQuency[:CW|FIXed]
on page 714
5.5.2.3 RF Frequency Dialog
The combined "RF Frequency / Phase..." dialog contains the parameters required for
configuring the frequency and settings like a frequency offset, or a multiplier factor of
an externally connected multiplier, see
Chapter 5.5.2.4, "Frequency Settings" ,
on page 202.
Furthermore, the dialog provides additional settings parameters which are described
in:
●
Chapter 5.5.3.2, "Phase Continuous Frequency" , on page 205
●
Chapter 5.5.3, "Phase" , on page 204
●
Chapter 5.5.4, "Reference Oscillator" , on page 209
●
Chapter 5.5.5, "Local Oscillator - LO Coupling" , on page 212
5.5.2.4 Frequency Settings
► To access the dialog for configuring the frequency settings, perform one of the fol-
lowing:
● Select "RF/A Mod > config... > RF Frequency > Frequency/Phase".
● Press the MENU key and select "RF/A Mod > RF Frequency > Frequency/
Phase".
In the upper section of the combined "RF Frequency / Phase ..." settings dialog you
can configure the frequency of the RF signal.
The remote commands required to define the settings are described in Chapter 7.16.6,
"SOURce:FREQuency Subsystem" , on page 712.
Frequency
Sets the RF frequency of the RF output connector. The frequency entered and dis-
played here corresponds to the frequency at the RF output, that means any offset entry
is not taken into consideration.
RF Signal and Analog Modulations - RF Block